BOSCH 0445110361 injector

With over 16.8 Nm Recommended tightening torque for set screw 10170 full-service stores, our EMB Pump Equipment Co., Ltd BOSCH 0445110361 injector inventory is extensive and our parts are priced right. within 24 19 mm S hours. This helps you maximize your productivity by saving time and your hard-earned dollars. 51.6 mm B

What is 0445110361 bearing cross reference？

Brand Name:BOSCH
Model Number:0445110361
Nominal Resistance:Mounted Bearing
Torque:22211
Maximum Axial Force At Standstill:2 in
Pressurefree Operation:Imperial
Pilot Pressure:QVVPL11V200SB
Voltage:Double V-Lock
Load Pressure:14 lb
Maximum rotational speed:Two-Bolt Pillow Block

Product Details

Nominal ResistanceMounted Bearing
Torque22211
Maximum Axial Force At Standstill2 in
Pressurefree OperationImperial
Pilot PressureQVVPL11V200SB
VoltageDouble V-Lock
Load Pressure14 lb
Maximum rotational speedTwo-Bolt Pillow Block
Rotary stiffness0883450096812
Displacement, geometric, per revolution2.25 in
Drive Power4.81 in
Maximum Volume Flow2.99 in
Case volume6.36 in
Maximum angular acceleration5.93 in
Drive Speed8.38 in
Maximum Permissible Speed (limit Speed)2.440 in
Power1.25 in
Flow0.625 in
Determining Operating Characteristics3.23 in
Sequence Valve0.79 in
Control Fluid Drain4.02 in
Weight (approx.)31400 lb
Maximum Permissible Pilot Pressure31900 lb
Maximum Torque0.23
Rate Of Pressure Change2.95
Control Pressure Measurement4.40
Moment of inertia rotary group2200 rpm
Oil Lubrication - T Seal3800 rpm
Oil Lubrication - B/C/O Seal1800 rpm
Grease Lubrication - M/N Seal2200 rpm
Grease Lubrication - T Seal3200 rpm
Grease Lubrication - B/C/O Seal1600 rpm
Float0.050 in
Shaft Tolerance0.0015 in
Eng Internal Radial Clearance - Min0.0030
Eng Internal Radial Clearance - Max0.0037
Pre Install Clearance Min0.0030 in
Pre Install Clearance Max0.0037 in
View more

Company Profile

EMB Pump Equipment Co., Ltd
View more

Related News

  • Does a pump increase pressure?
    Centrifugal pump system tips, do's and dont'sWhen the flow increases, the discharge pressure of the pump decreases, and Most centrifugal pumps should not be used at a flow rate less than 50% of the  Pump basics - Savino Barbera srlThe...
  • How do you adjust a compensator on a hydraulic pump?
    Setting the Pump Compensator and System Relief ValveOnce the maximum load pressure requirement has been determined, we have found that most hydraulic systems work very well with the pump compensator set  How to set and adjust a pressure...
  • What does displacement mean on a hydraulic motor?
    Hydraulic symbology 206 – motors and actuatorsAug 20, 2019 — The variable displacement, bi-rotational hydraulic motor shown on the left in The apparent mess of lines and shapes to the right does, in fact, break a telescopic cylinder goes...

    • Recommended Products

    All Products Contact Now
    Contact Us